irene
May 11th, 2005, 08:42 AM
Hello,
I would like to know if it's possible to use BlockSim in this case:
I have a quantity of parts to be tested , a test file is proposed .Different stresses are applied on the parts .
So, There are different failure modes.
Can I simulate a failure mode with a blockdiagram ?
Please help
Regards
I would like to know if it's possible to use BlockSim in this case:
I have a quantity of parts to be tested , a test file is proposed .Different stresses are applied on the parts .
So, There are different failure modes.
Can I simulate a failure mode with a blockdiagram ?
Please help
Regards