Diagramm

[Temanag]

Hello
I have a problem with the diagramm properties...
I have clicked in the right corner of diagramm´s field and reduced the size of all elements.
the problem is that I can not increase their size again...

[Arai.M]

Hello,
If you click again in the bottom right corner, you should get back the original size. What that is is the print layout mode. Alternatively, you can go to the View menu and uncheck Print Layout.
Hope this helps,
Arai

[Arai.M]

It has been brought to my attention that when the size of your diagram is smaller than the size of the print layout, the zoom changes so that you can see how the page that you are printing is going to look. Now, you can change the zoom back to normal in a couple of ways. You can add the Zoom toolbar to your menu, by default it is not there (right click in the menu bar and click on Zoom tools). A drop down appears with the current zoom and you can select 100%. You can also go to View in the menu and click on normal zoom (or zoom in/out). Note that changing the zoom leaves the print layout mode on if it was on before. You can turn it off with the instructions in the previous note.
Arai