Need some advice on the Weibull plot

[Clare]

Hi

I have just installed Weibull 7++.
I have 2 sets of data different condition.
I wish to use the following data to plot into weibull 7++software.

I have input data into the following folio...

Life data analysis folio / Folio data type (time to failures) / My data contains suspension (right sensored data)

Basically I wish to estimate the failure rate at 2000hrs? QCP also do the calculation. Can someone advice me? Thanks

[Pantelis]

Not sure if I follow your data or what you are trying to do. It may be better if you contacted our support. Not sure where you are located but you can get a list of phone numbers (or emails) from
http://www.reliasoft.com/contact.htm

This may be easier than trying to do this on the forum with postings back and forth. If you have Weibull++ (or a an evaluation version) ReliaSoft Support is free and fairly easy to get to.